Agilent 33120A User's Guide

More documents

Recommendations

Info

Chapter 4 Remote Interface ReferenceRS-232 Interface ConfigurationRS-232 Data Frame FormatA character frame consists of all the transmitted bits that make up asingle character. The frame is defined as the characters from the start bitto the last stop bit, inclusively. Within the frame, you can select thebaud rate, number of data bits, and parity type. The function generatoruses the following frame formats for seven and eight data bits.Connection to a Computer or TerminalTo connect the function generator to a computer or terminal, you musthave the proper interface cable. Most computers and terminals are DTE(Data Terminal Equipment) devices. Since the function generator is alsoa DTE device, you must use a DTE-to-DTE interface cable. These cablesare also called null-modem, modem-eliminator, or crossover cables.The interface cable must also have the proper connector on each endand the internal wiring must be correct. Connectors typically have9 pins (DB-9 connector) or 25 pins (DB-25 connector) with a “male”or “female” pin configuration. A male connector has pins inside theconnector shell and a female connector has holes inside the connector shell.If you cannot find the correct cable for your configuration, you mayhave to use a wiring adapter. If you are using a DTE-to-DTE cable, makesure the adapter is a “straight-through” type. Typical adapters includegender changers, null-modem adapters, and DB-9 to DB-25 adapters.Refer to the cable and adapter diagrams on the following page toconnect the function generator to most computers or terminals. If yourconfiguration is different than those described, order the 34399AAdapter Kit. This kit contains adapters for connection to othercomputers, terminals, and modems. Instructions and pin diagrams areincluded with the adapter kit.196
Chapter 4 Remote Interface ReferenceRS-232 Interface ConfigurationDB-9 Serial Connection If your computer or terminal has a 9-pinserial port with a male connector, use the null-modem cable includedwith the 34398A Cable Kit. This cable has a 9-pin female connector oneach end. The cable pin diagram is shown below.4DB-25 Serial Connection If your computer or terminal has a 25-pinserial port with a male connector, use the null-modem cable and 25-pinadapter included with the 34398A Cable Kit. The cable and adapter pindiagram is shown below.197
Page 6 and 7:
The Front-Panel Menu at a GlanceThe
Page 8 and 9:
The Rear Panel at a Glance1 Chassis
Page 11 and 12:
ContentsChapter 1 Quick StartTo pre
Page 13 and 14:
ContentsChapter 6 Application Progr
Page 15 and 16:
11Quick Start
Page 17 and 18:
Chapter 1 Quick StartTo prepare the
Page 19 and 20:
Chapter 1 Quick StartIf the functio
Page 21 and 22:
Chapter 1 Quick StartTo set the out
Page 23 and 24:
Chapter 1 Quick StartTo set a dc of
Page 25 and 26:
Chapter 1 Quick StartTo output a st
Page 27 and 28:
Chapter 1 Quick StartTo store the i
Page 29 and 30:
Chapter 1 Quick StartTo rack mount
Page 31 and 32:
22Front-PanelMenu Operation
Page 33 and 34:
Chapter 2 Front-Panel Menu Operatio
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Features and FunctionsYou will find
Page 58 and 59:
Chapter 3 Features and FunctionsOut
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Chapter 3 Features and FunctionsAmp
Page 76 and 77:
Chapter 3 Features and FunctionsAmp
Page 78 and 79:
Chapter 3 Features and FunctionsFre
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Chapter 3 Features and FunctionsBur
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Chapter 3 Features and FunctionsTri
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Chapter 3 Features and FunctionsArb
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Chapter 3 Features and FunctionsSys
Page 114 and 115:
Chapter 3 Features and FunctionsSys
Page 116 and 117:
Chapter 3 Features and FunctionsRem
Page 118 and 119:
Chapter 3 Features and FunctionsRem
Page 120 and 121:
Chapter 3 Features and FunctionsCal
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
124
Page 128 and 129:
Remote Interface Referenceœ SCPI C
Page 130 and 131:
Chapter 4 Remote Interface Referenc
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149: Chapter 4 Remote Interface Referenc
Page 228 and 229: 226
Page 230 and 231: Error Messagesœ Errors are retriev
Page 232 and 233: Chapter 5 Error MessagesExecution E
Page 240 and 241: Chapter 5 Error MessagesCalibration
Page 242 and 243: Chapter 5 Error MessagesArbitrary W
Page 244 and 245: 242
Page 246 and 247: Application ProgramsThis chapter co
Page 248 and 249:
Chapter 6 Application ProgramsC Lan
Page 250 and 251:
Chapter 6 Application ProgramsUsing
Page 252 and 253:
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
Chapter 6 Application ProgramsDownl
Page 260 and 261:
Page 262 and 263:
Page 264 and 265:
Page 266 and 267:
Page 268 and 269:
Page 270 and 271:
Page 272 and 273:
270
Page 274 and 275:
TutorialThe Agilent 33120A is capab
Page 276 and 277:
Chapter 7 TutorialDirect Digital Sy
Page 278 and 279:
Chapter 7 TutorialSignal Imperfecti
Page 280 and 281:
Chapter 7 TutorialCreating Arbitrar
Page 282 and 283:
Chapter 7 TutorialOutput Amplitude
Page 284 and 285:
Chapter 7 TutorialFloating Signal G
Page 286 and 287:
Chapter 7 TutorialAttributes of AC
Page 288 and 289:
Chapter 7 TutorialAttributes of AC
Page 290 and 291:
Chapter 7 TutorialModulationIn ampl
Page 292 and 293:
Chapter 7 TutorialModulationFrequen
Page 294 and 295:
Chapter 7 TutorialModulationFor tri
Page 296 and 297:
Chapter 7 TutorialModulationYou can
Page 298 and 299:
Chapter 7 TutorialModulationœ Set
Page 300 and 301:
Chapter 8 SpecificationsAgilent 331
Page 302 and 303:
Chapter 8 SpecificationsAgilent 331
Page 304 and 305:
302
Page 306 and 307:
IndexIndexCC examples, 244cables (R
Page 308 and 309:
IndexIndexinterface (remote)selecti
Page 310 and 311:
IndexIndexstringcalibration, 122dis
Page 312:
È Copyright Agilent Technologies,
show all

Agilent 33120A User's Guide

Create successful ePaper yourself

Delete template?

Save as template?