Agilent 33120A User's Guide

Chapter 4 Remote Interface ReferenceCalibration CommandsCalibration CommandsSee “Calibration Overview” starting on page 118 for an overview of thecalibration features of the function generator. For a more detaileddiscussion of the calibration procedures, see chapter 4 in the Service Guide.CALibration?Perform a calibration using the specified calibration value(CAL:VAL command). Before you can calibrate the function generator,you must unsecure it by entering the correct security code.CALibration:COUNt?Query the function generator to determine the number of times it hasbeen calibrated. Your function generator was calibrated before it left thefactory. When you receive your function generator, read the count todetermine its initial value. [ Stored in non-volatile memory ]œ The calibration count increments up to a maximum of 32,767 afterwhich it wraps-around to 0. Since the value increments by one foreach calibration point, a complete calibration will increase the valueby many counts.4CALibration:SECure:CODE Enter a new security code. To change the security code, you must firstunsecure the function generator using the old security code, and thenenter a new code. The calibration code may contain up to 12 characters.[ Stored in non-volatile memory ]CALibration:SECure:STATe {OFF|ON},Unsecure or secure the function generator for calibration. The calibrationcode may contain up to 12 characters. [ Stored in non-volatile memory ]CALibration:SECure:STATe?Query the secured state of the function generator. Returns “0” (OFF)or “1” (ON).193