Agilent 33120A User's Guide

Chapter 4 Remote Interface ReferenceUsing the APPLy CommandAPPLy Command Syntaxœ Because of the use of optional parameters in the APPLy commands(enclosed in square brackets), you must specify frequency to use theamplitude parameter, and you must specify both frequency andamplitude to use the offset parameter. The following statement isvalid (frequency and amplitude are specified; offset is omitted):"APPL:SIN 5.0E+3, 3.0"However, you CANNOT specify amplitude and offset without frequency.œ You can substitute “MINimum”, “MAXimum”, or “DEFault” in place ofspecific values for the frequency, amplitude, and offset parameters.For example, the following statement outputs a 3 Vpp sine wave at15 MHz (the maximum frequency for sine) with a -2.5 volt offset:"APPL:SIN MAX, 3.0, -2.5"4APPLy:SINusoid [ [, [,] ]]Output a sine wave with the specified frequency, amplitude, anddc offset. The waveform is output as soon as the command is executed.APPLy:SQUare [ [, [,] ]]Output a square wave with the specified frequency, amplitude, anddc offset. The waveform is output as soon as the command is executed.APPLy:TRIangle [ [, [,] ]]Output a triangle wave with the specified frequency, amplitude, anddc offset. The waveform is output as soon as the command is executed.APPLy:RAMP [ [, [,] ]]Output a ramp wave with the specified frequency, amplitude, anddc offset. The waveform is output as soon as the command is executed.143