Agilent 33120A User's Guide

Chapter 5 Error MessagesExecution Errors-224 Illegal parameter valueA discrete parameter was received which was not a valid choice forthe command. You may have used an invalid parameter choice.Example: DISP:STAT XYZ (XYZ is not a valid choice).-330 Self-test failedThe function generator’s self-test failed from the remote interface(*TST? command). In addition to this error, one or more specific errorsmay be reported. See also “Self-Test Errors,” on page 237.-350 Too many errorsThe error queue is full because more than 20 errors have occurred.No additional errors are stored until you remove errors from the queue.The error queue is cleared when power has been off, or after a *CLS(clear status) command has been executed.-410 Query INTERRUPTEDA command was received which sends data to the output buffer, but theoutput buffer contained data from a previous command (the previousdata is not overwritten). The output buffer is cleared when power hasbeen off, or after a device clear has been executed.-420 Query UNTERMINATEDThe function generator was addressed to talk (i.e., to send data over theinterface) but a command has not been received which sends data to theoutput buffer. For example, you may have executed an APPLy command(which does not generate data) and then attempted an ENTER statementto read data from the remote interface.5-430 Query DEADLOCKEDA command was received which generates too much data to fit in theoutput buffer and the input buffer is also full. Command executioncontinues but all data is lost.-440 Query UNTERMINATED after indefinite responseThe *IDN? command must be the last query command within acommand string. Example: *IDN?;:SYST:VERS?235