Cisco IOS Wide-Area Networking Configuration Guide - Free Books

Frame Relay Configuration ExamplesConfiguring Frame Relay• FRF.9 Compression for Subinterfaces Using the frame-relay map Command Example• FRF.9 Compression for Subinterfaces Example• Data-Stream Hardware Compression with TCP/IP Header Compression on a Point-to-PointSubinterface Example• Data-Stream Hardware Compression with TCP/IP Header Compression on a MultipointSubinterface Example• Data-Stream Hardware Compression with RTP Header Compression and Frame RelayFragmentation ExampleNoteShut down the interface or subinterface prior to adding or changing compression techniques. Althoughshutdown is not required, shutting down the interface ensures that it is reset for the new data structures.FRF.9 Compression for Subinterfaces Using the frame-relay map Command ExampleThe following example shows a subinterface being configured for FRF.9 compression using theframe-relay map command:interface serial2/0/1ip address 172.16.1.4 255.255.255.0no ip route-cacheencapsulation frame-relay IETFno keepaliveframe-relay map ip 172.16.1.1 105 IETF payload-compression FRF9 stacFRF.9 Compression for Subinterfaces ExampleThe following example shows a subinterface being configured for FRF.9 compression:interface serial2/0/0no ip addressno ip route-cacheencapsulation frame-relayip route-cache distributedno keepalive!interface serial2/0/0.500 point-to-pointip address 172.16.1.4 255.255.255.0no cdp enableframe-relay interface-dlci 500 IETFframe-relay payload-compression FRF9 stacData-Stream Hardware Compression with TCP/IP Header Compression on a Point-to-PointSubinterface ExampleThe following example shows the configuration of data-stream hardware compression and TCP headercompression on point-to-point interface 1/0.1:interface serial1/0encapsulation frame-relayframe-relay traffic-shaping!interface serial1/0.1 point-to-pointip address 10.0.0.1 255.0.0.0frame-relay interface-dlci 10072