12.07.2015 Views

Cisco IOS Wide-Area Networking Configuration Guide - Free Books

Cisco IOS Wide-Area Networking Configuration Guide - Free Books

Cisco IOS Wide-Area Networking Configuration Guide - Free Books

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Frame Relay <strong>Configuration</strong> ExamplesConfiguring Frame RelayFRF.12 Fragmentation on a Switched PVC <strong>Configuration</strong> ExampleIn the following example, FRF.12 fragmentation is configured in a map class called “data”. The “data”map class is assigned to switched pvc 20 on serial interface 3/3.frame-relay switching!interface Serial3/2encapsulation frame-relayframe-relay intf-type dce!interface Serial3/3encapsulation frame-relayframe-relay traffic-shapingframe-relay interface-dlci 20 switchedclass dataframe-relay intf-type dce!map-class frame-relay dataframe-relay fragment 80 switchedframe-relay cir 64000frame-relay bc 640!connect data Serial3/2 16 Serial3/3 20Frame Relay End-to-End Keepalive ExamplesThe following sections provide examples of Frame Relay end-to-end keepalive in different modes andconfigurations:• End-to-End Keepalive Bidirectional Mode with Default <strong>Configuration</strong> Example• End-to-End Keepalive Request Mode with Default <strong>Configuration</strong> Example• End-to-End Keepalive Request Mode with Modified <strong>Configuration</strong> ExampleEnd-to-End Keepalive Bidirectional Mode with Default <strong>Configuration</strong> ExampleIn the following example, the devices at each end of a VC are configured so that a DLCI is assigned toa Frame Relay serial interface, a map class is associated with the interface, and Frame Relay end-to-endkeepalive is configured in bidirectional mode using default values:! router1router1(config) interface serial 0/0.1 point-to-pointrouter1(config-if) ip address 10.1.1.1 255.255.255.0router1(config-if) frame-relay interface-dlci 16router1(config-if) frame-relay class vcgrp1router1(config-if) exit!router1(config)# map-class frame-relay vcgrp1router1(config-map-class)# frame-relay end-to-end keepalive mode bidirectional! router2router2(config) interface serial 1/1.1 point-to-pointrouter2(config-if) ip address 10.1.1.2 255.255.255.0router2(config-if) frame-relay interface-dlci 16router2(config-if) frame-relay class vceekrouter1(config-if) exit!router2(config)# map-class frame-relay vceek68

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!