Cisco IOS Wide-Area Networking Configuration Guide - Free Books

How to Configure Frame Relay PVC Bundles with QoS Support for IP and MPLSFrame Relay PVC Bundles with QoS Support for IP and MPLSStep 6Step 7Step 8Step 9Step 10Step 11Step 12Step 13Command or Actionencapsulation frame-relay [cisco |ietf]Example:Router(config-if)# encapsulation frame-relayip address ip-address mask [secondary]Example:Router(config-if)# ip address 10.1.1.1255.0.0.0frame-relay map protocol protocol-address {dlci| vc-bundle vc-bundle-name} [broadcast] [ietf |cisco]Example:Router(config-if)# frame-relay map ip 10.2.2.2vc-bundle MAIN-1frame-relay vc-bundle vc-bundle-nameExample:Router(config-if)# frame-relay vc-bundle MAIN-1encapsulation [cisco | ietf]Example:Router(config-fr-vcb)# encapsulation ietfmatch {dscp dscp-value | precedenceprecedence-value}Example:Router(config-fr-vcb)# match precedence 5pvc dlci [vc-name]Example:Router(config-fr-vcb)# pvc 100 1aclass nameExample:Router(config-fr-vcb-vc)# class premiumPurposeEnables Frame Relay encapsulation.• The default encapsulation method is cisco.Sets a primary IP address for the interface.• The optional secondary keyword specifies that theconfigured address is a secondary IP address. If thiskeyword is omitted, the configured address is theprimary IP address.(Optional) Maps between a next-hop protocol address and adata-link connection identifier (DLCI) destination address,and creates a PVC bundle if it does not already exist.• The protocol-address is the destination IP address.• The frame-relay map command is required formultipoint interfaces if Inverse ARP has been disabledor is not supported at the other end of the connection.Creates a PVC bundle if it does not already exist, and entersFrame Relay VC-bundle configuration mode.(Optional) Overrides the encapsulation type configured onthe interface and configures the Frame Relay encapsulationtype for the PVC bundle.• This command is available only when the PVC bundleis configured on a point-to-point subinterface.Establishes the type of matching to use between incomingpacket headers and PVC-bundle members.• The default match type is precedence.Creates a PVC-bundle member and enters Frame RelayVC-bundle-member configuration mode.• The vc-name argument is an optional name that can beused for referring to the PVC.(Optional) Assigns a map class to the PVC-bundle memberdefined in the previous step.8