Cisco IOS Wide-Area Networking Configuration Guide - Free Books

Frame Relay Configuration ExamplesConfiguring Frame Relayframe-relay intf-type dce!interface serial0encapsulation frame-relayframe-relay intf-type dce!connect one serial0 16 dialer1 100connect two serial0 17 dialer2 100dialer-list 1 protocol ip permitNoteNote that when Frame Relay switching is performed by using a dialer profile, encapsulation of theunderlying physical (BRI) interface must be configured as high-level data link control (HDLC).Traffic Shaping on Switched PVCs ExampleIn the example that follows, traffic on serial interface 0 is being shaped prior to entry to the Frame Relaynetwork. PVC 100/16 is shaped according to the “shape256K” class. PVC 200/17 is shaped using the“shape64K” class inherited from the interface.frame-relay switching!interface serial0encapsulation frame-relayframe-relay intf-type dceframe-relay traffic-shapingframe-relay class shape64Kframe-relay interface-dlci 16 switchedclass shape256K!interface serial1encapsulation frame-relayframe-relay intf-type dce!connect one serial0 16 serial1 100connect two serial0 17 serial1 200!map-class frame-relay shape256Kframe-relay traffic-rate 256000 512000!map-class frame-relay shape64Kframe-relay traffic-rate 64000 64000Traffic Policing on a UNI DCE ExampleIn the following example, incoming traffic is being policed on serial interface 1. The interface usespolicing parameters configured in map class “police256K”. PVC 100/16 inherits policing parametersfrom the interface. PVC 200/17 uses policing parameters configured in “police64K”.frame-relay switching!interface serial0encapsulation frame-relayframe-relay intf-type dce!interface serial1encapsulation frame-relayframe-relay policingframe-relay class police256K66