Cisco IOS Wide-Area Networking Configuration Guide - Free Books

DETAILED STEPSStep 1Step 2Command or ActionenableExample:Router> enableconfigure terminalPurposeEnables privileged EXEC mode.• Enter your password if prompted.Enters global configuration mode.Step 3Step 4Example:Router# configure terminalvc-class atm nameExample:Router(config)# vc-class atm aal5classencapsulation aal5Creates a VC class and enters VC class configurationmode.Specifies ATM AAL5 encapsulation for the PVC.Step 5Step 6Step 7Step 8Step 9Example:Router(config-vc-class)# encapsulation aal5endExample:Router(config-vc-class)# endinterface type slot/portExample:Router(config)# interface atm 1/0class-int vc-class-nameExample:Router(config-if)# class-int aal5classpvc [name] vpi/vci l2transportExample:Router(config-if)# pvc 1/200 l2transportxconnect peer-router-id vcid encapsulationl2tpv3Ends your configuration session by exiting to privilegedEXEC mode.Specifies the interface by type, slot, and port number, andenters interface configuration mode.Applies a VC class on an the ATM main interface orsubinterface.NoteYou can also apply a VC class to a PVC.Creates or assigns a name to an ATM permanent virtualcircuit (PVC), specifies the encapsulation type on anATM PVC, and enters ATM VC configuration mode.• The l2transport keyword indicates that the PVC isfor Layer 2 switched connections. After you enterthis command, the router enters ATM VCconfiguration mode.Binds the attachment circuit to a pseudowire VC.Example:Router(config-if-atm-l2trans-pvc)# xconnect10.13.13.13 100 encapsulation l2tpv377