Cisco IOS Wide-Area Networking Configuration Guide - Free Books

Table 4L2TPv3 Features Supported in a Native L2TPv3 Session (Continued)Native L2TPv3 FeatureL2TPv3 tunnel marking and traffic policingon the following types of ingress interfaces,when bound to a native L2TPv3 tunnelsession:- 802.1q (VLAN)- ATM- Channelized- Ethernet- Frame Relay DLCIsThe following conform, exceed, and violatevalues for the action argument are supportedfor the police command when QoS policiesare configured on an ISE/E5 ingress interfacebound to a native L2TPv3 tunnel.The set commands can also be used to set theIP precedence or DSCP value in the tunnelheader of a L2TPv3 tunneled packet on aningress interface.conform-action actions:set-prec-tunnelset-dscp-tunneltransmitexceed-action actions:dropset-clp (ATM only)set-dscp-tunnelset-dscp-tunnel and set-clp (ATM only)set-dscp-tunnel and set-frde(Frame Relay only)set-frde (Frame Relay only)set-prec-tunnelset-prec-tunnel and set-clp (ATM only)set-prec-tunnel and set-frde(Frame Relay only)transmitviolate-action actions:dropSee “QoS: Tunnel Marking for L2TPv3Tunnels” for information about how to use theL2TPv3 tunnel marking and traffic policingfeatures on Engine 2 (and earlier engine)interfaces bound to a TSC-based L2TPv3tunnel session.ISE Line Cards (Customer-facing)Supported4-port OC-3 POS ISE8-port OC-3 POS ISE16-port OC-3 POS ISE4-port OC-12 POS ISE1-port OC-48 POS ISE4-port OC-3 ATM ISE4-port OC-12 ATM ISE4-port Gigabit Ethernet ISE1-port channelized OC-12 (DS1) ISEISE SPAs:- 2-port T3/E3 serial- 4-port T3/E3 serial- 2-port channelized T3 to DS0- 4-port channelized T3 to DS0E5 Line Cards (Customer-facing)SupportedEngine 5 SPAs:- 1-port channelized STM-1c/OC-3cto DS0- 8-port channelized T1/E1- 8-port Fast Ethernet- 5-port Gigabit Ethernet- 10-port Gigabit Ethernet- 4-port OC-3/STM4 POS- 8-port OC-3/STM4 POS- 2-port OC-12/STM4 POS- 4-port OC-12/STM4 POS- 8-port OC-12/STM4 POS18