Cisco IOS Wide-Area Networking Configuration Guide - Free Books

HDLC Interfaceinterface serial 0/0ip address 192.168.1.2 2555.2555.2555.252xconnect 75.0.0.1 1 pw-class 12tpmatch protocol ipv6Manually Clearing an L2TPv3 Tunnel: ExampleThe following example demonstrates how to manually clear a specific L2TPv3 tunnel using the tunnelID:clear l2tun tunid 65432Configuring Frame Relay DLCI-to-DLCI Switching: ExampleThe following is a sample configuration for switching a Frame Relay DLCI over a pseudowire:pseudowire-class fr-xconnectencapsulation l2tpv3protocol l2tpv3ip local interface Loopback0sequencing both!interface Serial0/0encapsulation frame-relayframe-relay intf-type dce!connect one Serial0/0 100 l2transportxconnect 10.0.3.201 555 pw-class fr-xconnect!connect two Serial0/0 200 l2transportxconnect 10.0.3.201 666 pw-class fr-xconnectConfiguring Frame Relay Trunking: ExampleThe following is a sample configuration for setting up a trunk connection for an entire serial interfaceover a pseudowire. All incoming packets are switched to the pseudowire regardless of content.Note that when you configure trunking for a serial interface, the trunk connection does not require anencapsulation method. You do not, therefore, need to enter the encapsulation frame-relay command.Reconfiguring the default encapsulation removes all xconnect configuration settings from the interface.interface Serial0/0xconnect 10.0.3.201 555 pw-class serial-xconnect100