Cisco IOS Wide-Area Networking Configuration Guide - Free Books

class-map datamatch fr-de!policy-map MATCH-DEclass dataset ip precedence tunnel 3!ip routingip cef distributed!mpls label protocol ldpinterface Loopback0ip address 10.20.20.20 255.255.255.255!interface Ethernet1/0/0ip address 172.16.0.2 255.255.255.0tag-switching ip!interface Serial4/0/0encapsulation frame-relayservice input MATCH-DE!connect 100 Serial4/0/0 100 l2transportxconnect 10.10.10.10 100 encapsulation l2tpv3The next example shows how to configure the service policy called set_prec_tunnel_from_frde andattach it to a Cisco 12000 series ISE/E5 interface bound to a native L2TPv3 tunnel session. Note that ina native L2TPv3 session, you must attach the service policy to a DLCI (in the example, DCLI 100)instead of to a main interface (as in the preceding example).class-map match-any match-frdematch fr-de!policy-map set_prec_tunnel_from_frdeclass match-frdeset ip precedence tunnel 6class class-defaultset ip precedence tunnel 3!map-class frame-relay fr_100service-policy input set_prec_tunnel_from_frde!interface POS0/0description ISE: L2TPv3 Customer-facing interfaceframe-relay interface-dlci 100 switchedclass fr_100Configuring MLFR for L2TPv3 on the Cisco 12000 Series: ExampleThe following example shows how to configure L2TPv3 tunneling on a multilink Frame Relay bundleinterface on a Cisco 12000 series 2-port Channelized OC-3/STM-1 (DS1/E1) or 6-port Channelized T3line card:frame-relay switching!pseudowire-class mfrencapsulation l2tpv3ip local interface Loopback0!interface mfr0frame-relay intf-type dce108