Cisco IOS Wide-Area Networking Configuration Guide - Free Books

encapsulation aal5!interface atm 1/0class-int aal5classpvc 1/200 l2transportxconnect 10.13.13.13 100 encapsulation l2tpv3Verifying ATM AAL5 SDU Mode over L2TPv3 Configuration: ExamplesVerifying ATM AAL5 over MPLS in ATM VC Configuration ModeTo verify the configuration of a PVC, use the show atm vc command in privileged EXEC mode:Router# show atm vcVCD/ Peak Avg/Min BurstInterface Name VPI VCI Type Encaps Kbps Kbps Cells Sts2/0 pvc 9 900 PVC AAL5 2400 200 UP2/0 4 9 901 PVC AAL5 149760 N/A UPThe following show l2tun session command output displays information about ATM VC modeconfigurations:Router# show l2tun session briefSession Information Total tunnels 1 sessions 2LocID TunID Peer-address State Username, Intf/sess/cirVcid, Circuit41875 18252 10.0.0.2 est,UP 124, AT2/0:9/901111 0 10.0.0.2 est,UP 123, AT2/0:9/900Verifying ATM AAL5 over MPLS in VC Class Configuration ModeTo verify that ATM AAL5 over L2TPv3 is configured as part of a VC class, issue the show atmclass-links command. The command output shows the type of encapsulation and that the VC class wasapplied to an interface.Router# show atm class links 1/100Displaying vc-class inheritance for ATM1/0.0, vc 1/100:no broadcast - Not configured - using defaultencapsulation aal5 - VC-class configured on main interface...Configuring OAM Local Emulation for ATM AAL5 over L2TPv3: ExamplesConfiguring OAM Cell Emulation for ATM AAL5 over L2TPv3 in ATM VC Configuration ModeThe following configuration binds a PVC to an xconnect attachment circuit to forward ATM AAL5frames over an established L2TPv3 pseudowire, enables OAM local emulation, and specifies that AIScells are sent every 30 seconds:pw-class atm-xconnectencapsulation l2tpv3interface ATM 4/1pvc 5/500 l2transport97