Cisco IOS Wide-Area Networking Configuration Guide - Free Books

How to Configure Frame Relay Voice-Adaptive Traffic Shaping and FragmentationFrame Relay Voice-Adaptive Traffic Shaping and FragmentationStep 3Step 4Step 5Step 6Command or Actionmap-class frame-relay map-class-nameExample:Router(config)# map-class frame-relayVOICE-CLASSframe-relay fragment fragment_sizeExample:Router(config-map-class)# frame-relayfragment 80service-policy output policy-map-nameExample:Router(config-map-class)# service-policy outputSHAPEendPurposeSpecifies the name of a Frame Relay map class that is to becreated or modified.Enables Frame Relay fragmentation.NoteFor voice-adaptive fragmentation to work,fragmentation must be enabled here in a map class,or it can be configured directly on the interface.Attaches a policy map to an output interface, to be used asthe service policy for that interface.• Use this command to attach the shaping policy to themap class.Exits to privileged EXEC mode.Example:Router(config-map-class)# endEnabling Frame Relay Voice-Adaptive Traffic Shaping andFragmentation on the InterfaceSUMMARY STEPSPerform the following task to enable Frame Relay voice-adaptive traffic shaping and fragmentation onthe interface.1. enable2. configure terminal3. interface type number4. encapsulation frame-relay5. frame-relay fragmentation voice-adaptive [deactivation seconds]6. frame-relay fragment fragment-size end-to-end7. frame-relay interface-dlci dlci [ietf | cisco] [voice-cir cir]8. class name9. end8