Cisco IOS Wide-Area Networking Configuration Guide - Free Books

Configuring Frame RelayFrame Relay Configuration ExamplesIPX Routing ExampleThe following example shows how to send packets destined for IPX address 200.0000.0c00.7b21 out onDLCI 102:ipx routing 000.0c00.7b3b!interface ethernet 0ipx network 2abc!interface serial 0ipx network 200encapsulation frame-relayframe-relay map ipx 200.0000.0c00.7b21 102 broadcastSubinterface ExamplesBasic Subinterface ExampleThe following sections provide Frame Relay subinterface examples and variations appropriate fordifferent routed protocols and bridging:• Basic Subinterface Example• Frame Relay Multipoint Subinterface with Dynamic Addressing Example• IPX Routes over Frame Relay Subinterfaces Example• Unnumbered IP over a Point-to-Point Subinterface Example• Transparent Bridging Using Subinterfaces ExampleIn the following example, subinterface 1 is configured as a point-to-point subnet and subinterface 2 isconfigured as a multipoint subnet.interface serial 0encapsulation frame-relayinterface serial 0.1 point-to-pointip address 10.0.1.1 255.255.255.0frame-relay interface-dlci 42!interface serial 0.2 multipointip address 10.0.2.1 255.255.255.0frame-relay map ip 10.0.2.2 18Frame Relay Multipoint Subinterface with Dynamic Addressing ExampleThe following example configures two multipoint subinterfaces for dynamic address resolution. Eachsubinterface is provided with an individual protocol address and subnet mask, and the frame-relayinterface-dlci command associates the subinterface with a specified DLCI. Addresses of remotedestinations for each multipoint subinterface will be resolved dynamically.interface serial0no ip addressencapsulation frame-relayframe-relay lmi-type ansi!interface serial0.103 multipointip address 172.21.177.18 255.255.255.0frame-relay interface-dlci 30053