Cisco IOS Wide-Area Networking Configuration Guide - Free Books

Configuring Frame RelayFrame Relay Configuration Examples!interface serial 0.2 point-to-pointip unnumbered TokenRing1ip pim sparse-mode!bandwidth 384frame-relay interface-dlci 20Transparent Bridging Using Subinterfaces ExampleThe following example shows Frame Relay DLCIs 42, 64, and 73 as separate point-to-point links withtransparent bridging running over them. The bridging spanning tree views each PVC as a separate bridgeport, and a frame arriving on the PVC can be relayed back out on a separate PVC.interface serial 0encapsulation frame-relayinterface serial 0.1 point-to-pointbridge-group 1frame-relay interface-dlci 42interface serial 0.2 point-to-pointbridge-group 1frame-relay interface-dlci 64interface serial 0.3 point-to-pointbridge-group 1frame-relay interface-dlci 73SVC Configuration ExamplesSVC Interface ExampleThe following sections provide examples of Frame Relay SVC configuration for interfaces andsubinterfaces:• SVC Interface Example• SVC Subinterface ExampleThe following example configures a physical interface, applies a map group to the physical interface,and then defines the map group:interface serial 0ip address 172.10.8.6encapsulation frame-relaymap-group bermudaframe-relay lmi-type q933aframe-relay svc!map-list bermuda source-addr E164 123456 dest-addr E164 654321ip 131.108.177.100 class hawaiiappletalk 1000.2 class rainbow!map-class frame-relay rainbowframe-relay idle-timer 60!map-class frame-relay hawaiiframe-relay cir in 64000frame-relay cir out 6400055