Cisco IOS Wide-Area Networking Configuration Guide - Free Books

!Tunnel id 23456 is up, remote id is 65432, 1 active sessions!Control message authentication is on, 1 secrets configuredLast message authenticated with first digest secret!! The output below displays control channel password information for a tunnel which is! communicating with a peer that has only the new control channel authentication password! configured.!Tunnel id 56789 is up, remote id is 98765, 1 active sessions!Control message authentication is on, 2 secrets configuredLast message authenticated with second digest secretConfiguring a Pseudowire Class for Fragmentation of IP Packets: ExampleThe following is a sample configuration of a pseudowire class that will allow IP traffic generated fromthe CE router to be fragmented before entering the pseudowire:pseudowire class class1encapsulation l2tpv3ip local interface Loopback0ip pmtuip dfbit setConfiguring ATM VP Mode Single Cell Relay over L2TPv3: ExampleThe following configuration binds a PVP to an xconnect attachment circuit to forward ATM cells overan established L2TPv3 pseudowire:pw-class atm-xconnectencapsulation l2tpv3interface ATM 4/1atm pvp 5 l2transportxconnect 10.0.3.201 888 pw-class atm-xconnectVerifying ATM VP Mode Single Cell Relay over L2TPv3 Configuration: ExampleTo verify the configuration of a PVP, use the show atm vp command in privileged EXEC mode:Router# show atm vp 5ATM4/1/0 VPI: 5, Cell-Relay, PeakRate: 155000, CesRate: 0, DataVCs: 0,CesVCs: 0, Status: ACTIVEVCD VCI Type InPkts OutPkts AAL/Encap Status8 3 PVC 0 0 F4 OAM ACTIVE9 4 PVC 0 0 F4 OAM ACTIVETotalInPkts: 0, TotalOutPkts: 0, TotalInFast: 0, TotalOutFast: 0,TotalBroadcasts: 094