Cisco IOS Wide-Area Networking Configuration Guide - Free Books

Frame Relay Voice-Adaptive Traffic Shaping and FragmentationHow to Configure Frame Relay Voice-Adaptive Traffic Shaping and FragmentationDETAILED STEPSStep 1Step 2Command or ActionenableExample:Router> enableconfigure terminalPurposeEnables privileged EXEC mode.• Enter your password if prompted.Enters global configuration mode.Step 3Step 4Step 5Step 6Example:Router# configure terminalpolicy-map policy-mapExample:Router(config)# policy-map FR-VATSclass class-nameExample:Router(config-pmap)# class VOICEpriority bandwidth-kbpsExample:Router(config-pmap-c)# priority 10exitSpecifies the name of the policy map to be created ormodified.• Use this command to define the queueing policy for thepriority queue.Specifies the name of a class to be created and included inthe service policy.• The class name that you specify in the policy mapdefines the characteristics for that class and its matchcriteria as configured using the class-map command.Creates a strict priority class and specifies the amount ofbandwidth, in kbps, to be assigned to the class.Returns to policy map configuration mode.Step 7Step 8Step 9Example:Router(config-pmap-c)# exitclass class-nameExample:Router(config-pmap)# class DATAbandwidth bandwidth-kbpsExample:Router(config-pmap-c)# bandwidth 10endSpecifies the name of a class to be created and included inthe service policy.• The class name that you specify in the policy mapdefines the characteristics for that class and its matchcriteria as configured using the class-map command.Specifies the amount of bandwidth to be assigned to theclass, in kbps or as a percentage of the available bandwidth.Bandwidth must be specified in kbps or as a percentageconsistently across classes. (Bandwidth of the priorityqueue must be specified in kbps.)Exits to privileged EXEC mode.Example:Router(config-pmap-c)# end5