Cisco IOS Wide-Area Networking Configuration Guide - Free Books

Step 3Step 4Command or Actioninterface type slot/portExample:Router(config)# interfaceserial 0/0ip address ip-address mask[secondary]PurposeSpecifies the interface by type, slot, and port number, and enters interfaceconfiguration mode.Sets a primary or secondary IP address for an interface.Step 5Step 6Example:Router(config-if)# ip address172.16.128.4 255.255.255.252xconnect peer-ip-address vcidpw-class pw-class-nameExample:Router(config-if)# xconnect10.0.3.201 888 pw-classatm-xconnectmatch protocol ipv6Specifies the IP address of the peer PE router and the 32-bit VCI sharedbetween the PE at each end of the control channel and enters xconnectconfiguration mode.• The peer router ID (IP address) and virtual circuit ID must be a uniquecombination on the router.• pw-class pw-class-name—The pseudowire class configuration fromwhich the data encapsulation type (L2TPv3) is taken. The pw-classparameter binds the xconnect statement to a specific pseudowire class. Thepseudowire class then serves as the template configuration for allattachment circuits bound to it.Note The L2TPv3 session can also be provisioned manually. See the section“Manually Configuring L2TPv3 Session Parameters” for informationabout manually configuring the L2TPv3 session parameters.Enables protocol demultiplexing of IPv6 traffic.Example:Router(config-if-xconn)# matchprotocol ipv6Manually Clearing L2TPv3 TunnelsSUMMARY STEPSPerform this task to manually clear a specific L2TPv3 tunnel and all the sessions in that tunnel.1. enable2. clear l2tun {l2tp-class l2tp-class-name | tunid tunnel-id | local ip ip-address | remote ip ip-address| all}88