12.07.2015 Views

Cisco IOS Wide-Area Networking Configuration Guide - Free Books

Cisco IOS Wide-Area Networking Configuration Guide - Free Books

Cisco IOS Wide-Area Networking Configuration Guide - Free Books

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

• Configuring Protocol Demultiplexing for L2TPv3: Examples, page 99• Manually Clearing an L2TPv3 Tunnel: Example, page 100• Configuring Frame Relay DLCI-to-DLCI Switching: Example, page 100• Configuring Frame Relay Trunking: Example, page 100• Configuring QoS for L2TPv3 on the <strong>Cisco</strong> 7500 Series: Example, page 101• Configuring QoS for L2TPv3 on the <strong>Cisco</strong> 12000 Series: Examples, page 101• Configuring a QoS Policy for Committed Information Rate Guarantees: Example, page 107• Setting the Frame Relay DE Bit <strong>Configuration</strong>: Example, page 107• Matching the Frame Relay DE Bit <strong>Configuration</strong>: Example, page 107• Configuring MLFR for L2TPv3 on the <strong>Cisco</strong> 12000 Series: Example, page 108• Configuring an MQC for Committed Information Rate Guarantees: Example, page 109NoteAny Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Anyexamples, command display output, and figures included in the document are shown for illustrativepurposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.Configuring a Static L2TPv3 Session for an Xconnect EthernetInterface: ExampleL2TPv3 is the only encapsulation method that supports a manually provisioned session setup. Thisexample shows how to configure a static session configuration in which all control channel parametersare set up in advance. There is no control plane used and no negotiation phase to set up the controlchannel. The PE router starts sending tunneled traffic as soon as the Ethernet interface (int e0/0) comesup. The virtual circuit identifier, 123, is not used. The PE sends L2TP data packets with session ID 111and cookie 12345. In turn, the PE expects to receive L2TP data packets with session ID 222 and cookie54321.l2tp-class l2tp-defaultsretransmit initial retries 30cookie-size 8pseudowire-class ether-pwencapsulation l2tpv3protocol noneip local interface Loopback0interface Ethernet 0/0xconnect 10.0.3.201 123 encapsulation l2tpv3 manual pw-class ether-pwl2tp id 222 111l2tp cookie local 4 54321l2tp cookie remote 4 12345l2tp hello l2tp-defaults90

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!