Cisco IOS Wide-Area Networking Configuration Guide - Free Books

Frame Relay Configuration ExamplesConfiguring Frame Relay!interface serial0.104 multipointip address 172.21.178.18 255.255.255.0frame-relay interface-dlci 400IPX Routes over Frame Relay Subinterfaces ExampleThe following example configures a serial interface for Frame Relay encapsulation and sets up multipleIPX virtual networks corresponding to Frame Relay subinterfaces:ipx routing 0000.0c02.5f4f!interface serial 0encapsulation frame-relayinterface serial 0.1 multipointipx network 1frame-relay map ipx 1.000.0c07.d530 200 broadcastinterface serial 0.2 multipointipx network 2frame-relay map ipx 2.000.0c07.d530 300 broadcastFor subinterface serial 0.1, the router at the other end might be configured as follows:ipx routinginterface serial 2 multipointipx network 1frame-relay map ipx 1.000.0c02.5f4f 200 broadcastUnnumbered IP over a Point-to-Point Subinterface ExampleThe following example sets up unnumbered IP over subinterfaces at both ends of a point-to-pointconnection. In this example, router A functions as the DTE, and router B functions as the DCE. RoutersA and B are both attached to Token Ring networks.Configuration for Router Ainterface token-ring 0ip address 131.108.177.1 255.255.255.0!interface serial 0no ip addressencapsulation frame-relay IETF!interface serial0.2 point-to-pointip unnumbered TokenRing0ip pim sparse-modeframe-relay interface-dlci 20Configuration for Router Bframe-relay switching!interface token-ring 0ip address 131.108.178.1 255.255.255.0!interface serial 0no ip addressencapsulation frame-relay IETFbandwidth 384clockrate 4000000frame-relay intf-type dce54