AKD™ Installation Manual - TG Drives

AKD Installation | 8 Electrical Installation8.16.5 Digital Outputs (X7/X8)8.16.5.1 Digital Outputs 1 and 2The drive supplies 2 digital outputs (X7/5 to X7/8, see page 113). Choose the required function in the setupsoftware. Messages from pre-programmed functions stored in the drive can be output here. A list of these preprogrammedfunctions can be found in the setup software. If an output is to be assigned to a pre-programmedfunction, then the parameter set must be saved in the drive.Technical characteristics• 24 V IO power supply at terminals X7/8 and X7/6, 20 Vdc to 30 Vdc• All digital outputs are floating, DIGITAL OUT 1/2: terminals X7/7-8 and X7/5-6), max. 100 mA• Can be wired as active low or active high (see examples below)• Update rate: 250 µsWiring diagramKollmorgen | December 2009 119