AKD™ Installation Manual - TG Drives

AKD Installation | 5 Package5.1 Package SuppliedWhenadrivefrom theAKD seriesis ordered(seepage144), thefollowingitemsareincludedinthedrivepackage:• AKD drive• Printed copy of AKD Installation Manual (EU only)• Printed copy of AKD Quick Start• Printed copy of fault and warning card• CD-ROM containing the setup software, WorkBench, and all product documentation in digital format.• Mating connectors X1, X2, X3, X4 (if required), X7, and X8• Grounding plate, L-shape or Flat depending on AKD voltage tye• CAN termination connector (with CAN drives only)Accessories Sold SeparatelyThe mating SubD and RJ45 connectors are not included in the package.Accessories must be ordered separately if required; refer to your regional accessories manual:• EMC filters for 24 V and mains supply voltage, categories C2 or C3• External brake resistor• Motor cable. Assembled motor cables are available for all regions. EU customers may also order motorcable at custom lengths and assemble the cable with power connectors ordered separately.• Feedback cable. Assembled feedback cables are available for all regions. EU customers may alsoorder feedback cable at custom lengths and assemble the cable with power connectors ordered separately.• Motor choke, for motor cables longer than 25 m• Service cable to the network• Power cable, control cables, and fieldbus cables (as cutoff lengths)5.2 NameplateThe nameplate depicted below is attached to the side of the drive, sample data entries are for a 12 A type.Kollmorgen | December 2009 29