AKD™ Installation Manual - TG Drives

AKD Installation | 2 Safety2.1 Safety InstructionsDuring operation, hazards exist that can cause death, severe injury, or materialdamage. Do not open or touch the equipment during operation. Keep all coversand cabinet doors closed during operation. Only properly qualified persons mayhandle the equipment during installation and commissioning .• During operation, drives may have uncovered live components, dependingon their level of enclosure protection.• Control and power connections may be live, even though the motor is notrotating.• Drives may have hot surfaces during operation. The heat sink can reachtemperatures above 80°C.The danger of electrical arcing is present. Electrical arcing can damage contactsand injure personnel. Never undo any electrical connections to the drivewhile it is live.Wait at least 7 minutes after disconnecting the drive from the main supplypower before touching potentially live sections of the equipment (such as contacts)or removing any connections.Capacitors can have dangerous voltages present up to seven minutes afterswitching off the supply power. Always measure the voltage in the DC bus linkand wait until the voltage is below 40 V before handling components.Incorrect handling of the drive can lead to personnel injury or material damage.Read this documentation before installing and commissioning the drive. It isvital that you keep to the technical data and information on connection requirements(nameplate and documentation).Only properly qualified personnel may perform activities such as transport,installation, commissioning, and maintenance. Properly qualified persons arethose who are familiar with the transport, assembly, installation, commissioningand operation of the product, and who have the appropriate qualifications fortheir job. The qualified personnel must know and observe the following standards:• IEC 60364 and IEC 60664• national accident prevention regulationsThe manufacturer of the machine must produce a hazard analysis for themachine and take appropriate measures to ensure that unforeseen movementsdo not result in personnel injury or material damage.It is not allowed to modify this device without permission by the manufacturer.Check the Hardware Revision Number of the product (see product label). Thisrevision number must match the Hardware Revision Number on the cover pageof the manual.The drives contain electrostatically sensitive components which may be damagedby incorrect handling. Electrostatically discharge your body before touchingthe drive. Avoid contact with highly insulating materials (artificial fabrics,plastic film etc.). Place the drive on a conductive surface.Kollmorgen | December 2009 17