Download - Fuji Xerox Printers

WPS-PINThe PIN code of WPS-PIN can only be configured from the operator panel.NOTE:• WPS-PIN (Wi-Fi Protected Setup-Personal Identification Number) is a method to authenticate and register devices requiredfor wireless configuration by entering PIN assignments to a printer and computer. This setting, performed through an accesspoint, is available only when the access points of your wireless router supports WPS.• Before WPS-PIN starts, you will need to enter your PIN code at the web page of the wireless LAN access point. For details,refer to the manuals provided with the wireless LAN access point.1 Press the (Menu) button.2 Select Admin Menu, and then press the button.3 Select Network Setup, and then press the button.4 Select WPS Setup, and then press the button.5 Select PIN Code, and then press the button.6 Write down the displayed 8-digit PIN code or select Print PIN Code, and then press the button. The PINcode is printed.7 Select Start Config., and then press the button.8 Ensure that the message Please wait WPS Setting is displayed, and enter the PIN code displayed onstep 7 into the wireless LAN access point.NOTE:• For details about WPS operation on the wireless LAN access point, refer to the manual supplied with the wireless LANaccess point.When the WPS operation is successful and the printer is rebooted, wireless settings are correctly configured.Operator PanelAuto SSID Setup1 Press the (Menu) button.2 Select Admin Menu, and then press the button.3 Select Network Setup, and then press the button.4 Select Wireless Setup, and then press the button.The printer automatically searches the access points on wireless network.5 Select the desired access point, and then press the button.If the desired access point does not appear, go to "Manual SSID Setup" on page 109.NOTE:• Some hidden SSID may not be displayed. If the SSID is not detected, turn on SSID broadcast from the router.6 Enter the WEP key or pass phrase, and then press the button.The Restart Printer to apply setting message appears.7 Turn off the printer, and turn it on again to apply the settings.Wireless settings are correctly configured.IMPORTANT:• If the optional hard disk unit is not installed on your printer, note that the data in the memory are cleared when the printeris turned off.108 Printer Connection and Software Installation