Download - Fuji Xerox Printers

Defining Custom Paper SizesBefore printing, set the custom size on the print driver.NOTE:• When setting the paper size on the print driver and the operator panel, be sure to specify the same size as the actual printmedia used. Setting the wrong size for printing can cause printer failure. This is especially true if you configure a bigger sizewhen using a narrow width paper.• Using the Windows Print DriverOn the Windows print driver, set the custom size in the Custom Paper Size dialog box. This section explains theprocedure using Windows 7 and the PCL 6 driver as an example.An administrator’s password only allows users with administrator rights to change the settings. Users without therights of administrator can only view the contents.1 Click Start → Devices and Printers.2 Right-click the printer, and then select Printer properties.3 Select the Device Settings tab.4 Select Custom Paper Size and click Setup.5 Select the Create a New Form check box.6 Enter a name for the custom paper size in Name. Up to 31 characters can be used for the paper name.7 Specify the values for Width and Length either by entering the number directly or using the up arrow and downarrow buttons.The value for Width cannot be greater than that of Length, even if it is within the specified range.NOTE:• You can switch the units by selecting either Millimeters or Inches under Units.• If you do not want to share the custom paper size with other users, clear the Share it with Other Users check box.8 Click Save.9 If necessary, repeat steps 5 to 8 to define another custom size.10 Click Close.11 Click OK.Printing Basics 141