Download - Fuji Xerox Printers

• Port StatusNOTE:• Port Status feature is available only for the USB port on the rear of the printer.Purpose:To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then onagain.Values:DisableEnable *Disables the USB port.Enables the USB port.• Adobe ProtocolPurpose:To specify PostScript communication protocol. You can configure the Adobe Protocol settings for the wirednetwork. The change becomes effective after the printer is turned off and then on again.Values:AutoStandardBCPTBCP*BinarySets the PostScript communications protocol automatically.Sets the PostScript communications protocol to Standard.Sets the PostScript communications protocol to BCP.Sets the PostScript communications protocol to TBCP.Sets the PostScript communications protocol to Binary.System SettingsUse System Settings to configure a variety of printer features.NOTE:• Values marked by an asterisk (*) are the factory default menu settings.• Power Saver TimePurpose:To specify the time for transition to power saver mode.Values:Low PowerTimer1min *1–60 minSpecifies the time taken by the printer to enter Low Power mode after it finishes a job.Sleep Timer 4min * Specifies the time taken by the printer to enter Sleep mode after it has entered Low1–6 minPower mode.When you specify 1 minute for Low Power Timer, the printer enters power saver mode 1 minute after it finishes ajob. This uses much less energy, but requires more warm-up time for the printer. Specify 1 minute if your printershares an electrical circuit with room lighting and you notice lights flickering.Select a high value if your printer is in constant use. In most circumstances, this keeps the printer ready to operatewith minimum warm-up time. Select a value between 1 and 60 minutes for Low Power Timer if you want abalance between energy consumption and a shorter warm-up period.The printer automatically returns to the standby mode from the power saver mode when it receives data from thecomputer. You can also change the status of the printer to the standby mode by pressing the (Wake UP) buttonon the operator panel.Using the Operator Panel Menus 179