Download - Fuji Xerox Printers

• Deleting Stored JobsA job that has been stored will be deleted after printing if selected to do so on the operator panel. Otherwise, the jobremains stored until you delete them on the operator panel.NOTE:• The data in the memory is cleared when the printer is turned off. The data on the optional hard disk unit is not cleared evenwhen the printer is turned off.• Printing PDF Files Using PDF Bridge (Windows Only)The printer has the PDF Bridge feature, which enables you to print PDF files directly without a print driver. PrintingPDF files without a print driver is much easier and faster when compared to printing with a print driver. This sectiondescribes how to print PDF files using PDF Bridge.This section includes:• "Supported PDF Files" on page 133• "Using the ContentsBridge Utility" on page 133• "Using the Commands" on page 133Supported PDF FilesPDF files created on the following versions of Adobe ® Acrobat ® can be printed using PDF Bridge.• Adobe Acrobat 5.X (excluding some of the features added to PDF1.4)• Adobe Acrobat 6.X (excluding some of the features added to PDF1.5)• Adobe Acrobat 7.X (excluding some of the features added to PDF1.6)NOTE:• Some PDF files cannot be printed depending on how they are created. In such case, open the files and print them using aprint driver.Using the ContentsBridge UtilityThe ContentsBridge Utility is software that enables direct printing of PDF files by simply dragging and dropping filesonto the icon. To use the ContentsBridge Utility, refer to the manual included on the Driver CD Kit.Using the CommandsYou can also print PDF files using the lpr or ftp command. When you print using these commands, the following PDFsettings on the operator panel become effective.• Quantity• 2-Sided Print• Print Mode• Password• Collated• Output Size• Layout• Output ColorNOTE:• When you print using the lpr command, the print quantity must be set also using lpr command. In such case, the Quantitysetting on the operator panel becomes invalid. If you do not specify the quantity using the lpr command, the printer recognizesthe quantity as "1 set".• To print PDF files using the lpr or ftp command, you must enable the printer's LPD or FTP port using the operator panel orCentreWare Internet Services (default: Enable).Printing Basics 133