Download - Fuji Xerox Printers

• The Output Is Too LightProblemThe output is too light.ActionThe toner cartridges may be low or need to be replaced. Confirm the amount of tonerin each toner cartridge.1 Check the toner level in the Status Monitor window.2 Replace the toner cartridges as necessary.If the problem persists, disable Toner Saver in the print driver.Disable Toner Saver in the print driver. The following procedure uses the PCL 6driver as an example.1 On the Image Options tab, ensure that Off is selected in the Toner Saverdrop-down menu.If the problem persists, try changing the Paper Type setting in the print driver.The print media surface may be uneven. Try changing the Paper Type setting in theprint driver. For example, change the plain paper to heavyweight using a PCL 6driver.1 On the Paper/Output tab, change the Paper Type setting.If the problem persists, verify that the correct print media is being used.Verify that the correct print media is being used.See also:• "Usable Print Media" on page 116If not, use the print media recommended for the printer.If the problem persists, clean inside the printer by using the cleaning rod.Clean inside the printer by using the cleaning rod.See also:• "Cleaning the Raster Optical Scanner (ROS) Window" on page 252If the problem persists, replace the drum cartridges if you have spare cartridges.Replace the drum cartridges if you have spare cartridges.See also:• "Replacing the Drum Cartridges" on page 260• "Installing the Drum Cartridges" on page 263If the problem persists, contact the Fuji Xerox local representative office or anauthorised dealer.Troubleshooting 219