Download - Fuji Xerox Printers

• IP FilterNOTE:• IP Filter feature is available only when Protocol is set to LPD or Port9100.Purpose:To block data received from certain IP addresses through the wired or wireless network. You can set up to five IPaddresses. The change becomes effective after the printer is turned off and then on again.Values:n (n is 1-5) Address Sets the IP address for Filter n.Subnet Mask Sets the address mask for Filter n.Mode Off * Disables the IP Filter feature for Filter n.Accept Accepts an access from the specified IP address.Reject Rejects an access from the specified IP address.• 802.1xNOTE:• 802.1x feature is available only when the printer is connected using LAN cable and the 802.1x authentication is enabled usingCentreWare Internet Services. For details about setting 802.1x, see the Help on the CentreWare Internet Services.Purpose:To disable 802.1x authentication. The change becomes effective after the printer is turned off and then on again.DisableDisables 802.1x.• Initialize NVMPurpose:To initialize wired network data stored in non-volatile memory (NVM). After executing this function and rebooting theprinter, all wired network settings are reset to their default values.• Adobe ProtocolPurpose:To specify PostScript communication protocol for a parallel interface, you can configure the Adobe Protocol settingsfor the wired network. The change becomes effective after the printer is turned off and then on again.Values:Auto *StandardBCPTBCPBinarySets the PostScript communications protocol automatically.Sets the PostScript communications protocol to Standard.Sets the PostScript communications protocol to BCP.Sets the PostScript communications protocol to TBCP.Sets the PostScript communications protocol to Binary.USB SettingsUse the USB Settings menu to change printer settings affecting a USB port.NOTE:• Values marked by an asterisk (*) are the factory default menu settings.178 Using the Operator Panel Menus