Removing asbestos in workplaces - Compliance ... - WorkSafe Victoria

More documents

Recommendations

Info

AppendicesAppendix I – Removal of asbestos-contaminated dustthat is greater than ‘a minor contamination’This appendix provides an example of how to perform a specific asbestos removal task.It does not address hazards other than asbestos (such as fall from heights or electricalhazards) – these hazards also need to be identified and the associated risk controlled.1. Obtain and review the asbestos register or any other relevant documentationrelating to the presence of asbestos-contaminated dust (from the person whocommissioned the removal work).2. A class A-licensed removalist must perform the removal.3. Ensure a nominated supervisor is on site at all times when the removal is beingperformed.4. Establish where the removal area will be and move all items out of the areaor cover them with 200 micron plastic sheeting if they could be contaminatedduring the removal work.5. Identify and isolate the removal area with appropriately placed durable signsand barricades using methods which may include temporary fencing, bollards,tape, rope or plastic sheeting. Ensure signs and barricades remain in place untila satisfactory visual inspection is completed.6. Put on personal protective equipment (PPE), including disposable coveralls withhood, boots and respirator. Preference needs to be given to boots without lacesas laced boots can be difficult to decontaminate.7. The minimum respiratory protection for this task is a half-face mask with a P1particulate cartridge or alternatively, a disposable P1 respirator provided thata proper fit can be assured. If there is any uncertainty regarding respiratoryprotection, advice from a competent person (such as a hygienist) needs tobe obtained.8. Use damp cloths or an industrial vacuum cleaner fitted with a HEPA filterto collect the asbestos-contaminated dust.9. Place the waste into a 200 micron plastic waste bag or suitable alternatewaste container dedicated for asbestos waste that is clearly labelled withan appropriate warning sign indicating asbestos waste.10. Once all contaminated dust, used rags and waste have been placed in wastecontainers and all tools have been cleaned, begin the personal decontaminationprocess.11. Carry out personal decontamination in a designated area. The method ofpersonal decontamination may vary. The following is one method:• Clean the disposable coveralls and respirator while still wearing them.Coveralls can be cleaned using a HEPA vacuum, damp rag or fine waterspray and the respirator can be cleaned with a wet rag or cloth.• While still wearing the respirator, remove coveralls turning them inside-outto entrap any remaining contamination and then place them into an asbestoswaste bag.• Remove the respirator. If a non-disposable respirator was used, inspect itto ensure it is free from contamination, clean it with a wet rag if necessary,then store in a container. Disposable respirators do not require cleaning.They need to be placed into an asbestos waste bag or waste containerdedicated for asbestos waste.98 Compliance code / Removing asbestos in workplaces WorkSafe Victoria
Appendices12. Ensure all waste bags are goose-necked, the exterior cleaned then doublebagged and all waste containers are sealed.13. Place all waste containers in a secure storage facility or transport vehiclefor disposal.14. After completing the removal, perform a visual clearance to ensure that thereis no visible asbestos residue. Consider seeking a competent independentperson’s visual assessment to confirm that there is no visible asbestos residue.15. Transport the waste in accordance with EPA Victoria requirements.16. Dispose of the waste bags/containers at a site licensed by the EPA Victoria toaccept waste asbestos.WorkSafe Victoria Compliance code / Removing asbestos in workplaces 99
Page 3 and 4:
Appendix A - The compliance framewo
Page 6 and 7:
IntroductionConsultation7. By law,
Page 8 and 9:
General requirements of the Occupat
Page 11 and 12:
Regulatory prohibitionsUse of compr
Page 13 and 14:
Legislation that applies to asbesto
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
General requirements for all asbest
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Additional requirements for license
Page 48 and 49:
Additional requirements for license
Page 50 and 51: Additional requirements for license
Page 58 and 59: Specific requirements for removalof
Page 68 and 69: Paraoccupational air monitoring and
Page 74 and 75: AppendicesAppendix A - The complian
Page 76 and 77: AppendicesAsbestos removal workThe
Page 78 and 79: AppendicesAppendix C - Examples of
Page 80 and 81: AppendicesPPacking materials for ga
Page 82 and 83: AppendicesAppendix E - Guide to the
Page 84 and 85: AppendicesSelection of appropriate
Page 86 and 87: AppendicesAppendix F - Pro forma co
Page 88 and 89: Appendices6. Decontamination proced
Page 90 and 91: AppendicesCONTROL PLAN FOR ASBESTOS
Page 92 and 93: Appendices5. Decontamination proced
Page 94 and 95: Appendix G - Example of an asbestos
Page 96 and 97: AppendicesAppendix G - Example of a
Page 98 and 99: AppendicesThe following are example
Page 102 and 103: AppendicesAppendix J - Removal of n
Page 104 and 105: Appendices22. Once all removed asbe
Page 106 and 107: Appendices15. Place used rags into
Page 108 and 109: Appendices13. Place the waste into
Page 110 and 111: Appendices13. Ensure waste bags are
Page 112 and 113: Appendices16. Perform a visual clea
Page 114 and 115: Appendices14. Place the waste into
Page 116 and 117: AppendicesAppendix Q - Information
Page 118: AppendicesAppendix S - Documents as
show all

Removing asbestos in workplaces - Compliance ... - WorkSafe Victoria

Create successful ePaper yourself

Delete template?

Save as template?