Leica GPS1200+ System Field Manual

17.3 Coding & LineworkDescriptionAccessCONFIGURECoding & Linework,Coding pageThe settings on this screen define the method of coding. For information on configuringand using SmartCodes refer to GPS1200+ Technical Reference Manual.Select Main Menu: Config...\Survey Settings...\Coding & Linework Settings.Description of fieldsField Option DescriptionNever, On or Off Determines if quick coding is never available,activated or available but deactivated. 1, 2 or 3 Available unless .Sets the mostly used number of digits for thequick code.After Point orBefore Point Default Valuesor Last UsedAvailable unless .Determines if a free code measured with a quickcode is stored before or after the point.Determines the attribute values displayed undercertain circumstances. This is applicable to boththe storing and displaying of attribute values.Always Prompt The screen XX Enter Mandatory Attribute willalways appear when codes, having one or moreattributes of attribute type mandatory, are beingstored.Only If No Value The screen XX Enter Mandatory Attribute willonly appear when codes, having one or moreattributes of attribute type mandatory, are beingstored without an attribute value.Code ChangeOnlyWith CodelistWithoutCodelistOnly Pt Codesor All CodesChoicelistThe screen XX Enter Mandatory Attribute willonly appear when a new code with a mandatoryattribute was selected.Codes stored within the job codelist can beselected to code points, lines and areas.Codes stored within the job codelist cannot beselected to code points, lines and areas. Eachcode must be entered manually.Either only point codes or all codes of the jobcodelist will be available in the choicelist for/ in a display mask of anapplication program. Selecting a line/area codeopens a new line/area.Available for . Whenthis field is active, surveyed points that have thesame code attached are strung to one line.Config...\Survey Settings... GPS1200+ 107