Leica GPS1200+ System Field Manual

IF parameters forANDTHENare to be configured PARAM (F3) changes toCONFIGURE Real-Time StopCriteria. Refer to paragraph"CONFIGURE Real-Time StopCriteria".CONFIGUREPost-Process StopCriteriaDescription of fieldsThe parameters shown on this screen depend on the setting for in CONFIGURE Point Occupation Settings.Field Option DescriptionUser inputUser inputOutputUser inputSets the required observation time for eachpoint. Counting time starts when OCUPY (F1) ispressed.Sets the required number of observations thatshould be recorded at each point. Countingobservations starts when OCUPY (F1) ispressed.Displays the rate at which static raw observationsare logged as configured in CONFIGURELogging of Raw Obs.Sets the required observation time dependingon the number of satellites available. Countingtime starts when OCUPY (F1) is pressed. Thereceiver stops measuring when the set length oftime for a certain number of satellites is reached.Should the number of available satelliteschange during observation, the observationsalready recorded will be taken into account.Next stepStep Description1. CONT (F1) closes the screen.2. CONT (F1) returns to the screen from where CONFIGURE Point OccupationSettings was accessed.114 GPS1200+ Config...\Survey Settings...