Leica GPS1200+ System Field Manual

25.2.2 Configuring to Connect to a ServerRequirementsConfigure connectto a server step-bystepThe configurations from the previous chapter must have been completed. Refer to"25.2.1 Configuring an Access to the Internet".Step Description1. Select Main Menu: Config...\Interfaces....2. CONFIGURE InterfacesHighlight Real-Time.3. EDIT (F3) to access CONFIGURE Real-Time Mode.4. CONFIGURE Real-Time Mode Select the type of data to be received from the Internet.5. CONT (F1) to return to CONFIGURE Interfaces.6. Highlight Real-Time.7. CTRL (F4) to access CONFIGURE Set NET Port.8. CONFIGURE Set NET Port The server to be accessed in the Internet. Opening thechoicelist accesses CONFIGURE Server to Connect where new serverscan be created or existing servers can be selected or edited. The IP address of the server to be accessed in theInternet. The host name of the server to be accessed in the Internet. ForRX1250 receivers only. The port of the Internet server through which the data isprovided. Each server has several ports for various services. Allows for automatic connection between the roverand the Internet when a point is occupied during a survey. Ending the pointoccupation also ends the Internet connection.9. CONT (F1) to return to CONFIGURE Interfaces.Once the receiver is connected to the server a message is displayed in themessage line.10. CONT (F1) to return to GPS1200+ Main Menu.11. USER12. STAT (F3) to access STATUS Status Menu.13. Highlight Interfaces....14. ENTER to access STATUS Interfaces.15. STATUS Interfaces208 GPS1200+ NTRIP via Internet