Leica GPS1200+ System Field Manual

25.2 Configuring a Real-Time Rover for Using NTRIP Service25.2.1 Configuring an Access to the InternetRequirements • Firmware v1.5 or higher must be loaded on the GPS1200+ receiver.• Firmware v1.42 or higher must be loaded on the RX1200.Configure accessto Internet step-bystepA GPRS device can be connected in a clip-on-housing or with RX1250 via Bluetooth.Step Description1. Select Main Menu: Config...\Interfaces....2. In CONFIGURE Interfaces highlight Internet.3. EDIT (F3) to access CONFIGURE Internet Interface.4. CONFIGURE Internet Interface Some providers ask for a user ID to allow connecting to theInternet via GPRS. Contact your provider if a user ID needs to be used. Some providers ask for a password to allow connecting tothe Internet via GPRS. Contact your provider if a password needs to beused.5. DEVCE (F5) to access CONFIGURE GPRS Internet Device.6. CONFIGURE GPRS Internet DevicesHighlight the GPRS / Internet device to be used.NEW (F2) to create a new GPRS / Internet device.SRCH (F4) Available on RX1250 with and a Bluetoothdevice being selected. To search for all available Bluetooth devices.If more than one Bluetooth device is found a list of available devices isprovided.7. CONT (F1) to return to CONFIGURE Internet Interfaces.8. CONT (F1) to return to CONFIGURE Interfaces.9. CTRL (F4) to access CONFIGURE GPRS/Internet Connection.10. CONFIGURE GPRS/Internet Connection Available for some devices. The Access Point Name of a serverfrom the network provider, which allows access to data services. Contactyour provider to get the correct APN. Mandatory for using GPRS.CODES (F3) Available for digital cellular phones of GSM technology. Toenter the Personal Identification Number of the SIM card. If the PIN islocked for any reason, for example the wrong PIN was entered, input thePersonal UnblocKing code for access to the PIN.11. CONT (F1) to return to GPS1200+ Main Menu.206 GPS1200+ NTRIP via Internet