Leica GPS1200+ System Field Manual

Description of fieldsField Option DescriptionNone, Referenceor RoverLeicaLeica 4GCMR/CMR+RTCM v3.1RTCM 1,2 v2RTCM 9,2 v2RTCM 18,19 v2RTCM 20,21 v2AutomaticSBAS, EGNOS,WAAS, MSAS,EGNOS (Test),WAAS (Test), orGAGAN activates a rover realtimeinterface.Refer to "20.2.3 Configuration of a ReferenceReal-Time Interface" for information about thesereal-time data formats.The availability of the following options dependon the selection made for inCONFIGURE SBAS Tracking Mode.Wide Area Augmentation SystemEuropean Geostationary Navigation OverlayServiceMTSAT Satellite-based Augmentation Systemwhere MTSAT stands for Multi-functional TransportSATelliteGPS Aided Geo Augmentation Navigation. Bluetooth x Available for RX1250. The Bluetooth port whichwill be used for the interface functionality.Clip-onNETxPort xAvailable for RX1250. The clip-on-contacts. It isused for RX1250 with GHT56 when a device isattached to the GHT56.Available for an activated Internet interface. Ifthese ports are not assigned to a specific interface,then these ports are additional remoteports.The physical port P1, P2 or P3 on the instrumentto which the device is attached.Output Available on RX1250 with and a Bluetooth device being selected.The ID address of the SmartAntenna to be used.Choicelist The receiver type used at the reference. If thereal-time data format does not contain the informationof the receiver type certain correctionsbased on the information of the receiver type areapplied in order to provide correct results. Thereal-time data formats Leica, Leica 4G, CMR,CMR+ and RTCM v3.1 contain this information.This is mainly important when a System300receiver or a receiver from a different manufactureris used as reference.Config...\Interfaces... - General GPS1200+ 143