Download - Fuji Xerox Printers

Examples of Settings for SunOS 4.1.4The examples below show printer settings for SunOS 4.1.4 where the printer host name isprinter1.1. Registering a printer (printer name: P001) supporting the PostScript language###chosen PS decomposer on printer##P001 | printerPS | Auto select PS:\:lp=:rp=PS:rm=printer1:\:sd=/usr/spool/P001lpd:\:lf=/usr/adm/printer1-errs:mx#02. Registering a printer (printer name: P002) supporting the PostScript language thatfeeds paper from an A4-size paper tray for 2 sided printing###chosen PS decomposer on printer##P002 | printerPS:\:lp=:rp=PS_A4:rm=printer1:\:sd=/usr/spool/P002lpd:\:lf=/usr/adm/printer1-errs:mx#03. Registering PS01 set using CentreWare Internet Services###chosen PS decomposer on printer##P003 | printerPS:\:lp=:rp=PS01:rm=printer1:\:sd=/usr/spool/P003lpd:\:lf=/usr/adm/printer1-errs:mx#0Important• To specify multiple entries for the logical printer, make sure each printer entry is assigned its uniquespool directory. If a single spool directory is used for multiple printer entries, the printer select option maynot function correctly.Note• Add the printer name to the initial field of /etc/printcap. To specify multiple printer names, separate themby “|”.• lp: The connected port device. No need to specify.• rp: This is the printer name of the remote host. The printer name corresponds to the printlanguage/mode.The output style may be specified at the same time. The parameters for specifying a style are thesame as those available for the -C option. As the example of (2) shows, insert “_” between theprinter name and output parameters. You can enter up to 14 characters.If PS%n or PLT%nH is specified for the printer name as in the example of (3), however, the printerdoes not operate normally with an output style different from the preset one.Set a printer name corresponding to the print language/mode and output style.• rm: This is the host name of the remote printer. Input the host name registered with /etc/hosts.• sd: This is the spool directory. Specify the absolute path of the spool directory which must be created.• lf: This is the error log file. Create one if it does not already exist.• mx#0: The spool size limit is cancelled.Refer to• Manuals, such as online manuals, that came with various workstations• For details about the -C option: “7.5 -C Option (lpr Command)” (P. 50)7.2 Setting Up the Workstation 41