Download - Fuji Xerox Printers

When SMB Spool Is Set to [Off] (Non-spool Mode)All the print data spooled in the printer receive buffer, including print data which is beingoutput, will be deleted. When the printer is switched on again, the print data will not befound.However, if the power is switched off immediately after the print data has been sent, thedata may be stored in the computer. In this case, when the power is switched on again, thestored print data will be printed first even if new print data has been specified.PrintingTake note of the following when printing:When SMB Spool Is Set to [Hard Disk] or [Memory] (Spool Mode)If the print data is larger than the hard disk or the remaining memory capacity at the pointof receiving data, the data will not be received by the printer.Note• Some client computers may re-send immediately when the print data has exceeded the receivingcapacity. When this occurs, the client computer appears as if it has crashed. To rectify this situation, theclient computer must be stopped from sending print data.When SMB Spool Is Set to [Off] (Non-spool Mode)The printer will process print data as soon as data is being received. If the printer hasaccepted a print request from a computer, it will not receive another print request fromanother computer.When the IP Address or Computer Name Is ChangedWhen the IP address or computer name of a computer is changed, it may not be able toprocess enquiries or deletion requests from the printer correctly. Make sure the printer isfree of all spooled data and then switch off/on the printer.Note• The function to stop/eject print data spooled to the printer spool can be operated from the printer controlpanel. Refer to the Setup and Quick Reference Guide for information on the operation.When Printer Is in Offline ModeIf the printer receives print request from a computer when it is in offline mode, it will notreceive the data and an error message dialog box will be displayed on the computer.However, with SMB, print data will be sent from the computer even in offline mode.Deleting JobsFor Windows NT 4.0, you cannot delete jobs if Service Pack 4 and other items noted aboveare not installed. If you delete jobs while the computer is receiving data, an error messagewill be displayed. When this happens, the Retry button on the error message is not effective.10.2 On Using SMB 61