Download - Fuji Xerox Printers

Switching the Power On/OffTake note of the following when switching off the printer:When LPD Spool Is Set to [Memory] (Spool Mode)All the print data spooled in the printer memory, including print data which is being output,will be deleted. When the printer is switched on again, the print data will not be found.However, if the printer is switched off immediately after the print data has been sent, thedata may be stored on the computer. In this case, when it is switched on again, the storedprint data will be printed first even if new print data has been instructed.When LPD Spool Is Set to [Hard Disk] (Spool Mode)All the spooled print data, including print data which is being printed, will be saved. Whenthe power is switched on again, the stored print data will be printed first even if new printdata has been instructed.When LPD Spool Is Set to [Off] (Non-spool Mode)All the print data spooled in the printer receive buffer, including print data which is beingoutput, will be deleted. When the printer is switched on again, the print data will not befound.However, if the power is switched off immediately after the print data has been sent, thedata may be stored on the computer. In this case, when the power is switched on again, thestored print data will be printed first even if new print data has been sent.Printing From WindowsTake note of the following when printing from Windows:• In the spool mode, if the print data is bigger than the remaining capacity of the hard diskor the memory at the point of receiving, the data will not be received by the printer.Note• Some client computers may re-send immediately when the print data has exceeded the receivingcapacity. When this occurs, the client appears as if it has crashed.To rectify this situation, the client computer must be stopped from sending print data.• In the non-spool mode, printing will commence once data starts to be received by theprinter. Therefore, if the printer has accepted a print request from a computer, it will notreceive another print request from another computer.• For PCL and DUMP, the specification for the number of copies is invalid.58 10 Precautions and Limitations