Installation Manual

Chapter 6 ��������
Page or the WBM Operator Home Page is displayed directly. It presents a summary of
the system's activity.
6.3.3.1.4 How to disconnect
To disconnect, click on Disconnect in the navigation bar. Your connection has been
deactivated.
Remark:
After 30 minutes of inactivity, disconnection is automatic.
6.3.4 Connecting your e-communication server to the LAN
6.3.4.1 Configuration procedure
The necessary hardware on Alcatel-Lucent OmniPCX Office Communication Server is:
- a CPUe-1/CPUe-2 board
- an ISDN T0 or T2 connector
- a client station connected to the LAN
- a LAN switch (LANX8, LAN X16 or external switch)
The items required on the client terminal are:
- the latest release of the OMC software for the administrator
- an Internet browser: Internet Explorer (release 5 or later) or Netscape Navigator (release 6
or later)
- a subscription to an Internet Service Provider
6.3.4.1.1 Installation procedure
1. Start a OMC session on socket RJ45 of the CPU board.
2. Change the IP default address on the Internet Access board to an IP address that is
compatible with the existing LAN.
3. Connect the CPU board to an available RJ45 socket on the LAN using an Ethernet cable.
The IP addresses of the different cards can be accessed through the heading OMC ->
PABX Client -> Hardware and limits-> IP cards.
6.3.5 Setting an Internet Connection
6.3.5.1 Configuration procedure
6.3.5.1.1 SUBSCRIPTION TO A ISP
A subscription with an ISP is necessary to access the Internet. After you have subscribed, the
ISP sends you back essential information for installing you Internet access. This information
must be entered when configuring Alcatel-Lucent OmniPCX Office Communication Server.
The information required to install the Internet access varies according to the type of
connection to be established.
6-22 ������������ � ����� � ����� ���� � ������������ ������