Installation Manual

More documents

Recommendations

Info

Chapter 6 �� - Testing the remote address by pinging the ISP's router. This checks that the router is working properly. - DNS configuration check: this test is used to verify that the DNS configuration entered in the system is correct and, if not, it is used to dynamically locate the DNS servers present on the IAP's premises. - Resolution of the IP address for the URL "www.ietf.org": checks that DNS resolution is working correctly. - DNS ping: this test is carried out if DNS resolution isn't working. It ascertains whether the problem is due to an incorrect IP address or to the DNS service itself. - Ping on www.ietf.org: tests the accessibility of a site present on the Internet. 6-28 ��
�� 7 �� 7.1 Maintenance Level 1 7.1.1 Maintenance This module provides maintenance advice on different hardware components of the Alcatel-Lucent OmniPCX Office Communication Server system. 7.1.1.1 BATTERY MAINTENANCE Alcatel-Lucent OmniPCX Office Communication Server systems (except the Alcatel-Lucent OmniPCX Office Compact Edition) are supplied with internal batteries that provide back-up power in the event of a mains power failure. Alternatively, all systems may be optionally equipped with an external battery pack to provide back-up power. To guarantee system shutdown without data loss in the event of a mains power failure or if the mains plug is unplugged from the wall socket, replace the batteries every two years. This maintenance operation is vital to guarantee sufficient power autonomy to allow the files to be saved before the system shuts down. Before replacing batteries, the system must be powered down and the power cable removed from the mains supply. - To replace internal batteries, the rear panel of the system cabinet must be removed and the battery drawer pulled out. - To replace external batteries, the external battery box must be opened. To maintain a good balance, replace all the batteries at the same time with batteries of the same type, from the same manufacturer and from the same batch. Make sure you respect the correct polarities when replacing batteries. There is a risk of explosion if the batteries are incorrectly replaced. Used batteries must be disposed of according to the battery manufacturer's instructions. The batteries are supplied uncharged. File saving in the event of a power failure can only be guaranteed once the batteries have been charged; that is, about 12 hours after turning on the system (CPU-1/CPU-2/CPU-3/CPUe-1/CPUe-2 switch in ON position). 7.1.1.1.1 Internal battery characteristics - number: 1 (Rack 1), 2 in parallel (Rack 2) or 3 in series (Rack 3) - sealed lead battery - 1,2 Ah / 12 V - fire resistance better than or equal to UL94-V2 7.1.1.1.2 External battery characteristics - number: up to 2 for CE and Compact Edition 2nd Generation, up to 3 for S and M systems, up to 6 for L systems �� 7-1
Page 1 and 2:
Compact Edition, Advanced Edition,
Page 3 and 4:
��
Page 5 and 6:
��
Page 7 and 8:
��
Page 9 and 10:
�� 1 ��
Page 11 and 12:
The EC labeling indicates that this
Page 13 and 14:
Note: Figure 1.4: Second Generation
Page 15 and 16:
�� 2 ��
Page 17 and 18:
- 14 ports. - 1 CPU slot + 1 MIX sl
Page 19 and 20:
2.3 Installation 2.3.1 Overview 2.3
Page 21 and 22:
Board Function Optional boards Conn
Page 23 and 24:
Board Function Optional boards Conn
Page 25 and 26:
WAN Green LED showing good WAN func
Page 27 and 28:
2.4.1.7 AMIX-1 X/Y/Z Boards These b
Page 29 and 30:
Each category-5 RJ45 connector has
Page 31 and 32:
DAUGHTER BOARDS CPU-1/ CPU-2 CPUe-1
Page 33 and 34:
Boards Slots 1-2 CPU Slot CPU-1, CP
Page 35 and 36:
Board MIX Slot CPU Slot CPU-2, CPU-
Page 37 and 38:
�� 3 ��
Page 39 and 40:
3.2.1.1 Voice services available in
Page 41 and 42:
Controlled services Relevant softwa
Page 43 and 44:
PIMphony Pro All 0 +1 250 PIMphony
Page 45 and 46:
�� 4 ��
Page 47 and 48:
4.1.1.2 ENVIRONMENT 4.1.1.2.1 Clima
Page 49 and 50:
RJ45 pin 1 2 3 4 5 6 7 8 LAN TX+ TX
Page 51 and 52:
Access Type Impedance Alcatel Refle
Page 53 and 54:
System - Reflexes terminal distance
Page 55 and 56:
Caution: The AFU-1 board (daughter
Page 57 and 58:
The PRA board is connected to a dig
Page 59 and 60:
Category 5 cable, FTP or STP, imped
Page 61 and 62:
4.2.1.7.3 Connecting an alarm The a
Page 63 and 64:
- A single doorphone with doorstrik
Page 65 and 66:
External battery units are availabl
Page 67 and 68:
3. Place the batteries flat in the
Page 69 and 70:
6. Close the unit and secure it wit
Page 71 and 72:
c. Connect the two units using the
Page 73 and 74:
7. Remove the mounting clip and the
Page 75 and 76:
You must first prepare the external
Page 77 and 78:
5. Close the unit and secure it wit
Page 79 and 80:
4.3.1.5.1 Alcatel-Lucent OmniPCX Of
Page 81 and 82:
Attaching the line cable: - Turn th
Page 83 and 84:
List of abbreviations - TD: Transmi
Page 85 and 86:
For Alcatel-Lucent First and Easy R
Page 87 and 88:
- Manual, if the terminals are not
Page 89 and 90:
- Initialize the set - Program keys
Page 91 and 92:
Static 1. Connect the power supply.
Page 93 and 94:
Figure 4.50: Alcatel-Lucent IP Touc
Page 95 and 96:
For an initialization that is Dynam
Page 97 and 98:
- AOM Alcatel-Lucent 8 series and A
Page 99 and 100:
2. Select Name and enter the name t
Page 101 and 102:
In fact, only the direct call key c
Page 103 and 104:
42 additional keys. - Add-On Module
Page 105 and 106:
4.7.1 Hardware description 4.7.1.1
Page 107 and 108:
4.7.2.2 Jumpers _ _ _ c h a n g e -
Page 109 and 110:
_ _ _ c h a n g e - e n d _ _ _ 1.
Page 111 and 112:
Both cables should have the same le
Page 113 and 114:
There is no hardware configuration
Page 115 and 116:
_ _ _ c h a n g e - e n d _ _ _ Not
Page 117 and 118:
1 1926.720 1927.584 2 1924.992 1924
Page 119 and 120:
External antennae According to the
Page 121 and 122:
The solution proposed alternates tw
Page 123 and 124:
4.9.1.1.2 Ethernet network access b
Page 125 and 126: 4.9.1.3 E-MAIL Configure the Intern
Page 127 and 128: 4.10.3 Limits Supported Windows OS
Page 129 and 130: esource keys are not preserved. The
Page 131 and 132: _ _ _ c h a n g e - e n d _ _ _ Int
Page 133 and 134: It is possible to add one or two mo
Page 135 and 136: �� 5 ��
Page 137 and 138: ��
Page 139 and 140: ��
Page 141 and 142: ��
Page 143 and 144: ��
Page 145 and 146: ��
Page 147 and 148: There are 10 pages of virtual keys
Page 149 and 150: �� 6 ��
Page 151 and 152: digits, national or with *). number
Page 153 and 154: 10: Number of numbers still availab
Page 155 and 156: This function is only available if
Page 157 and 158: 6.1.1.14 SYSTEM RESET This menu is
Page 159 and 160: - A connection to the switch connec
Page 161 and 162: 1. Open OMC. 2. Open the Tools fold
Page 163 and 164: Access to modes 2, 3, 4 and 5 is pa
Page 165 and 166: - Metering • Cost of telephone me
Page 167 and 168: Alcatel-Lucent OmniPCX Office Commu
Page 169 and 170: navigation bar. The administration
Page 171 and 172: ISDN connection 1. Connection accou
Page 173 and 174: and modify the desired parameters.
Page 175: Click on Wizards in the navigation
Page 179 and 180: Always take anti-static precautions
Page 181 and 182: 7.1.1.6.1 Handling 7.1.1.6.2 Storag
Page 183 and 184: �� 8 ��
Page 185 and 186: Direct Dialing In. Direct external
Page 187 and 188: ITU International Telecommunication
Page 189 and 190: PSTN Public Switched Telephone Netw
Page 191 and 192: URL Uniform Resource Locator. Addre
show all

Installation Manual

Create successful ePaper yourself

Delete template?

Save as template?