Installation Manual

Chapter 4 ������������ ��� �������
For performance and safety reasons, the system must always be connected to the
ground. The ground must be connected prior to all the other connections.
For performance and safety reasons, the whole system must always be coupled
to the ground. The ground must be connected before any other connections.
The ground protection connection terminal must always be connected to the
ground. Protective grounding terminal shall be permanently connected to the ground.
4.3.1.6 POWER UP
Having made all the connections, it is now time to power up the system.
- Insert the mains cable in the socket on the rear of the unit.
- Press the ON/OFF button. The system will reinitialize (duration: 3 to 4 minutes).
To stop the system:
- Press the ON/OFF button, the RED LED will flash.
- Wait until the LED stops flashing and is lit steadily (between 15 seconds and 3 minutes
depending on the configuration): the system is switched off.
4.3.1.6.1 Power up of Alcatel Reflexes terminals
On powering up, Reflexes sets execute a self-test:
- Display Test
- Test of the LEDs or icons on the terminal and add-on module, if any
- Audio test
If this sequence is correct, the display on the Alcatel Reflexes terminals shows the system
date: Monday 01 January 00h00.
After powering up, you can activate the system from an Advanced Reflexes terminal or by
OMC (refer to the specific notice).
4.4 Reflexes and e-Reflexes Terminals
4.4.1 Reflexes Terminals
4.4.1.1 Installation procedure
4.4.1.1.1 REMINDER: SYSTEM - Alcatel Reflexes TERMINAL SEPARATION
- SYT type 0.5 mm cable: 800 m (terminal without option) or 600 m (terminal with S0 or Z
option)
- 278 type 1.6 mm cable: 1200 m (terminal without option) or 850 m (station with S0 or Z
option)
4.4.1.1.2 Premium AND Advanced Reflexes TERMINALS
4-36 ������������ � ����� � ����� ���� � ������������ ������