Installation Manual
Installation Manual
Installation Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
For an<br />
initialization<br />
that is<br />
Dynamic mode<br />
or Proprietary<br />
dynamic mode<br />
You do not have a DHCP<br />
server<br />
Initializing the IP Touch set<br />
To initialize the IP Touch set, refer to the table below.<br />
Procedure<br />
Static mode - Refer to table: Initialization<br />
procedure<br />
- Obtain from your network<br />
administrator:<br />
• An IP address for the<br />
IP Touch set<br />
• The subnetwork mask<br />
• The router address<br />
• The TFTP server<br />
address (master VoIP<br />
board address)<br />
table 4.24: Initialization procedure<br />
������������ ��� �������<br />
Note:<br />
You need to know your set's<br />
directory number.<br />
1. Connect the power supply.<br />
2. Before initialization phase 5 starts, press i, then the # key.<br />
The Main menu appears.<br />
3. If the set was previously in static mode, choose IP Parameters from the Main<br />
menu.<br />
The IP Parameters menu appears.<br />
4. Choose Dynamic.<br />
5. Save by pressing the soft key in the upper left part of the display.<br />
6. Exit the Main menu by pressing the soft key in the upper right part of the display.<br />
������������ � ����� � ����� ���� � ������������ ������ 4-51