Installation Manual
Installation Manual
Installation Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
- Initialize the set<br />
- Program keys<br />
Prerequisites<br />
None.<br />
Connecting the sets<br />
This section describes how to:<br />
- Connect an IP Touch set to the LAN (Local Area Network)<br />
- Connect the power supply<br />
Prerequisites<br />
None.<br />
Connecting an IP Touch set to the LAN<br />
To connect the set to the LAN:<br />
1. Turn the set over so that you can see its base.<br />
2. Plug the RJ45 cable into the set's LAN connector.<br />
3. Connect the RJ45 cable to the LAN itself.<br />
Connecting power supply<br />
The set can be supplied from two possible power sources:<br />
- An AC/DC external adapter which is a 42V power supply<br />
A female jack is used to connect the power adapter. The AC/DC external adapter is the<br />
same for IP Touch and e-Reflex sets.<br />
- Power over Ethernet (PoE)<br />
The supply via Ethernet can be implemented using a 802.3af standard-compatible switch.<br />
To supply power via an AC/DC external adapter:<br />
1. Plug the appropriate cable from the adapter into the set's power supply connector.<br />
2. Connect the plug from the adapter to the mains power supply.<br />
Initialization starts.<br />
Initializing the sets<br />
This section describes how to:<br />
- Choose the initialization mode<br />
- Initialize the IP Touch set<br />
Prerequisites<br />
The IP Touch set must be connected to the:<br />
- LAN<br />
- Power supply<br />
������������ ��� �������<br />
������������ � ����� � ����� ���� � ������������ ������ 4-45