HP BladeSystem Onboard Administrator User Guide - HP Business ...

2 If redundant Onboard Administrator firmware versions do not match, the settings are not automatically synchronized.
Synchronize the firmware by using the Insight Display, GUI, or CLI command, and then the settings are automatically
synchronized to the replaced Onboard Administrator module.
Access requirements
To access HP BladeSystem Onboard Administrator web interface, you must have the Onboard Administrator
IP address and a compatible web browser. Access to the application must be through HTTPS (HTTP packets
exchanged over an SSL-encrypted session).
HP BladeSystem Onboard Administrator web interface requires an XSLT-enabled browser with support for
JavaScript 1.3 or the equivalent.
The following browsers are supported for use with Onboard Administrator:
• Microsoft® Internet Explorer
• Mozilla Firefox
• Other browsers can be used, but are not supported.
Before running the application, you must enable the following browser settings:
• ActiveX (for Microsoft® Internet Explorer)
• Cookies
• JavaScript
If you receive a notice that your browser does not have the required functionality, be sure that your browser
settings meet the preceding requirements, and see Recovering the administrator password (on page 19) .
If using the Japanese language version of Onboard Administrator with Microsoft® Internet Explorer, you
must install the appropriate language pack within Microsoft® Windows®.
To access HP BladeSystem Onboard Administrator CLI, use HP BladeSystem Onboard Administrator IP
address and a terminal or terminal application. To access the CLI interface, you must use Telnet or SSH,
depending on which of these protocols are enabled.
To access the CLI management and notification features, the following ports must be open on any router
between Onboard Administrator and any computers used to access or monitor Onboard Administrator.
Protocol Incoming port Outgoing port
SSH 22 —
Telnet 23 —
SMTP — 25
Browser access 80 80
Browser access encrypted 443 443
SNMP get/set 161 —
SNMP traps — 162
LDAP — 636
Terminal services pass-through from PC to iLO 3389 —
Virtual media from PC to iLO 17988 —
Remote syslog — 514
You can change LDAP and Remote syslog port numbers.
Introduction 10