HP BladeSystem Onboard Administrator User Guide - HP Business ...

398 No variable values are passed in for searching.
401 Enclosure Firmware Management is currently disabled.
402 The Enclosure Firmware Management ISO URL is not set.
403 The operation cannot be performed while Enclosure Firmware Management is running.
404 Unable to mount ISO or validate version information.
Check URL and validate ISO is available from URL entered.
405 Unable to open firmware log.
406 The blade's firmware has not been discovered.
407 An error occurred while reading the firmware log.
408 Enclosure Firmware Management is not supported by this device type
409 Firmware ISO image is in use, changing url is not allowed.
410 Blade must be powered off before starting Enclosure Firmware Management.
411 Unable to change passwords for any LDAP or HPSIM users.
412 Enclosure Firmware Management is not available. To use this feature, it needs to be unlocked.
413 Enclosure Firmware Management is not supported on the Active OA hardware present.
414 Could not persist firmware management log.
Insight Display screen shot errors
1 Missing credentials.
2 The getLCDImage CGI process has caught the SIGSEGV signal.
3 Could not acquire access to the image in a reasonable amount of time.
4 Cannot open semaphores.
5 Produce SEMV does not work.
6 Consume SEMV does not work.
7 Cannot lock the image file.
8 Cannot open the image file.
9 Cannot seek in the image file.
10 Unable to resume session.
11 Insufficient privileges.
Onboard Administrator factory default settings
When resetting the HP BladeSystem Onboard Administrator to factory defaults, the administrator password
is not reset to factory default. It remains set to the password that was last specified. In the event that the
administrator password must be reset to factory defaults (as included on the tag that shipped with the
Onboard Administrator), proceed to the Recovering the administrator password (on page 19) section in this
guide.
Troubleshooting 256