HP BladeSystem Onboard Administrator User Guide - HP Business ...

Disabled—Disables powerdelay for this bay. HP BladeSystem Onboard Administrator grants power to this
bay based on its power settings: for a device configured to auto power-on, the device is granted power
following an enclosure power cycle after all the Onboard Administrator configuration checks are complete.
Enabled—Enables powerdelay for this bay. HP BladeSystem Onboard Administrator turns on this bay based
on the number of seconds elapsed following the detection of an enclosure power cycle event.
No Poweron—Prevents component power on for the bays with this configuration until after the HP
BladeSystem Onboard Administrator logs PowerDelay has completed for the selected devices.
At this time, if the device is configured to auto power-on, the device grants power following an enclosure
power cycle after all the Onboard Administrator configuration checks are complete.
If the device is configured to disable auto poweron, the device remains off following an enclosure power
cycle independent of the setting of power delay for that bay.
Device Bays Standard tab and Double Dense tabs
The Device Bays Standard tab indicates the current settings for all the primary bays based on the type of
enclosure. To change a setting on a particular device bay, use the menu under the Enabled column and select
Enabled, Disabled or No Poweron. If Enabled is selected, a power delay in seconds must be entered in the
Delay column for this bay. The minimum value is 1 second; the maximum value is 3600 seconds.
If double dense servers are installed in an enclosure the power delay settings for Side A and Side B are
controlled in the Double Dense Side A and Double Dense Side B tabs.
Interconnect Bays tab
Configuring the HP BladeSystem c7000 enclosure and enclosure devices 75