HP BladeSystem Onboard Administrator User Guide - HP Business ...

20 The submitted bay is not assigned.
21 An error occurred while opening the requested blade system log.
22 The submitted value is already in use.
23 The first character in the submitted value is not valid.
24 The submitted value contains an invalid character.
25 The submitted value is too short.
26 The submitted value is too long.
27 The submitted trap receiver already exists.
28 The maximum number of trap receivers already exists.
29 The maximum number of IP managers already exists.
30 The IP Manager already exists.
31 The submitted bay number is out of range.
32 The submitted IP address is not valid.
33 The submitted value is null.
34 An error occurred while generating an event.
35 An error occurred opening the enclosure system log.
36 The submitted date and/or time value was not formatted correctly.
37 An error occurred while opening the Onboard Administrator's system log.
38 The NMI Dump failed for the submitted blade.
39 Setting the UID for the submitted blade failed.
40 Setting the environment variable for the submitted blade failed.
41 Setting the boot order for the submitted blade failed.
42 Setting the power control for the submitted blade failed.
43 Setting the max power for the submitted bladed failed.
44 Shutting down the submitted blade failed.
45 Clearing the submitted blade failed.
46 Getting blade information for the submitted blade failed.
47 Getting blade status for the submitted blade failed.
48 Getting sensor information for the submitted sensor failed.
49 Setting the submitted rack name failed.
50 Getting power supply information for the submitted power supply failed.
51 Getting power supply status for the submitted power supply failed.
52 Getting power supply measurements for the submitted power supply failed.
53 Setting the Onboard Administrator's UID state failed.
54 Getting the Onboard Administrator's status failed.
Troubleshooting 246