Puritan Bennett 560 Ventilator User's Manual - Covidien

To connect the oxygen supply system to the ventilator:
Refer to Figure 4-16 as required:
Installation and Assembly
1. Inspect the oxygen supply’s connector (Figure 4-16, item 1) to ensure that connector’s
black O-ring (item 2) is not missing.
2. Push the oxygen supply’s oxygen connector (item 1) into the ventilator’s oxygen connector
(Figure 4-16, item 3).
• the ventilator’s oxygen connector’s locking stud (item 4) retracts.
• the ventilator’s oxygen connector’s locking tab (item 5) is released, ensuring that the oxygen
connection is locked and secured in place.
1
2 3
Figure 4-16. Connecting the Oxygen Supply System
To disconnect the oxygen supply system from the ventilator:
Note:
Ensure the oxygen source is turned off prior to placing the ventilator in Standby or turning off the ventilator.
1. Stop the oxygen flow from the oxygen supply.
2. Press the locking tab of the ventilator’s oxygen connector, as shown in Figure 4-17, to unlock
the oxygen connection.
Figure 4-17. Disconnecting the Oxygen Supply System
3. Disconnect the oxygen supply’s oxygen connector by pulling it towards you.
The ventilator’s oxygen connector’s locking stud (Figure 4-16, item 4) will then extend
outwards,
which is required before the oxygen connector can be reconnected.
User’s Manual 4-15
4
5