Manual T*SOL basic 5.0 - Valentin Software
Manual T*SOL basic 5.0 - Valentin Software
Manual T*SOL basic 5.0 - Valentin Software
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
User <strong>Manual</strong> <strong>T*SOL</strong> 6 System Selection<br />
6.1.7 A7 - Thermosyphon Systems<br />
Image: A7 - Thermosyphon system with continuous<br />
flow heater, stand-alone<br />
Image: A7.1 - Thermosyphon system without<br />
continuous flow heater<br />
Thermosyphon systems operate on the difference in density between hot and cold water. They therefore<br />
require no circulation pumps and additional control loops.<br />
Two systems differentiated by an optional continuous flow heater for auxiliary heating are available for<br />
calculation purposes.<br />
Under System Definition , you can enter the type of collector, the continuous flow heater (fuel and<br />
power), and DHW consumption.<br />
In contrast to other systems, the parameters for the tank are predefined. Circulation is not possible.<br />
6.1.8 A10 - System with Solar Tank and Continuous Flow Heater<br />
Image: A10 - System with continuous flow heater<br />
Single coil tank with solar loading. This system uses acontinuous flow heater to set the desired DHW<br />
temperature when solar power is insufficient for this purpose. In contrast to system A16, a circulation<br />
system can be installed here.<br />
Under System Definition, you can enter the power and fuel (electricity, oil, natural gas) for the continuous<br />
flow heater.<br />
Dr. <strong>Valentin</strong> Energie<strong>Software</strong> GmbH page 40 / 104